Pax A920 Adding POS Network

Pax A920 Adding POS Network

1.)To begin you will need to navigate to the Home Screen by exiting the Broad POS app.  This can be done by swiping up from the bottom of the touch screen and pressing the circle button to return HOME. 

2.) Open the device settings by tapping on the gear icon. 



3.) Open the WiFi Settings

4.) Add Network by selecting the 3 dot icon on the top right. Select Add Network. 


5.) Enter the following network parameters. Make sure to select Advanced Options. Save when finished. 


    • Related Articles

    • Pax A35

      This email will contain information on what a store should do when they receive their PAX A35, EMV chip reader.      An ethernet cable will need to be connected from the red adapter attached to the PAX A35 to the switch. The switch should be a small ...

    • Pax A35 Wifi Setup Instructions

      Pax A35 WiFi Setup Instructions Connect Power This device is powered using a USB C connection and outlet. Home Screen Navigate to the Home Screen. The quickest way if it is currently running the Portico app is to hold the red and green button till a ...

    • How to set a Static IP address on PAX S300

      Press FUNC + 1 at same time and enter Password (default 916860) Press down arrow and 2 for Communication Password 916860 Down arrow and 3 for LAN Paramaters 1 for LAN Type 2 for Static The static information can be found by running the command ...

    • ParPay Setup

      The following steps are used to set up and configure ParPay. Environmental requirements As opposed to Heartland/Pax devices, where the payment device needs static LAN information for the register to look for and reach out to on the LAN, ...