How to set a Static IP address on PAX S300

How to set a Static IP address on PAX S300

    • Press FUNC + 1 at same time and enter Password (default 916860)
    • Press down arrow and 2 for Communication
    • Password 916860
    • Down arrow and 3 for LAN Paramaters
    • 1 for LAN Type
    • 2 for Static
    • The static information can be found by running the command ipconfig on the POS. There are four fields that need to be filled out.
      • IP Address
      • Subnet Mask
      • Gateway IP
      • DNS IP 


    • Related Articles

    • Pax A35 Wifi Setup Instructions

      Pax A35 WiFi Setup Instructions Connect Power This device is powered using a USB C connection and outlet. Home Screen Navigate to the Home Screen. The quickest way if it is currently running the Portico app is to hold the red and green button till a ...

    • Pax A35

      This email will contain information on what a store should do when they receive their PAX A35, EMV chip reader.      An ethernet cable will need to be connected from the red adapter attached to the PAX A35 to the switch. The switch should be a small ...

    • Pax A920 Adding POS Network

      1.)To begin you will need to navigate to the Home Screen by exiting the Broad POS app.  This can be done by swiping up from the bottom of the touch screen and pressing the circle button to return HOME.  2.) Open the device settings by tapping on the ...

    • ParPay Setup

      The following steps are used to set up and configure ParPay. Environmental requirements As opposed to Heartland/Pax devices, where the payment device needs static LAN information for the register to look for and reach out to on the LAN, ...

    • Barcode Scanner Configuration (DS9208)

      Symbol DS9208 Barcode Scanner – Configuration After installing the Symbol Virtual COM port drivers and connecting the scanner…. STEP 1 – Scan code below to restore default settings…. STEP 2 – Scan code below to set configuration…. STEP 3 – Set Static ...